Is My Property Suitable for Cavity Wall Insulation?

We all probably all agree that saving energy is something we all should do. We’ve recently been told that cavity wall insulation is among the finest economical improvements that we can undertaken. Even so, homeowners are sometimes worried as to whether or not to find the cavity walls insulated. spouwmuurisolatie

Tooth cavity wall insulation is the sole energy efficiency improvement that the householder are not able to see once it has been done. So you aren’t completely in the hands of the company that is carrying out the work for you. 

Presently there are some things you have to know so you are comfortable that cavity wall efficiency will be suited to your home.

Firstly what is a cavity wall?

Just about all properties built after 1930’s are built with tooth cavity walls. It’s a process of building an outside wall separated by a gap (the cavity) and an inner wall. The two walls are tied up together with wall jewelry. The key reason why cavities were helped bring in was going to separate the two wall surfaces, as the older sound wall properties could sometimes transmit damp across the walls as it was one ongoing mass. So with a cavity wall, if water did penetrate the exterior wall it would not transmit to the interior wall. By insulating the cavities with special drinking water repellent insulation, the two walls continue to be not linked and you find the added benefit for insulating the house.

The majority of properties built after 1930 are suitable, but you will need to have a survey done to check it for appropriateness. Be sure that your survey provides you with all the following information.

The property must be of standard construction with the two walls built of just one of these 3 types.

Packet and brick

Brick and block

Block and block out (these houses usually have a rendered finish).

These types of house types are not well suited for cavity wall padding:

Concrete properties

Steel presented houses

Timber framed

Program built residences

The tooth cavity must minimal 50mm.

At this time there is no full load, or partial fill efficiency already present in the cavities.

The cavity must be clean. A boroscope inspection of the tooth cavity provides this information.

At this time there must be no building defects that may impact the effectiveness of the installation.

There has to be no proof of rising damp or penetrating damp. Black mold on walls is often mistaken for penetration drenched. This problem is induced by moisture landing on cold walls and tooth cavity wall insulation may help to ease this. The survey should identify what type of damp you have.

There are no access issues that will prevent the property from being properly insulated.

In case the survey confirms that the house is suitable then you can safely proceed with having the work done. Most of the checking will be covered by a 25 year CIGA assurance. CIGA (Cavity Wall Padding Grants Agency) is the independent agency that helps the guarantees. With federal government grants available for efficiency, there are surveying companies that provides free online surveys and independently recommend the best system and company to attempt the work for you.

© My Info Blog
CyberChimps